![]() You can change the dynamic parameter in the command to blackhole, static, security, sticky, and summary to check blackhole MAC address entries, static MAC address entries, secure dynamic MAC address entries, sticky MAC address entries, and statistics on MAC address entries, respectively. display mac-address GigabitEthernet 0/0/XĬ) Check all the dynamic MAC address entries in the system. Check the MAC address entries learned by a switch.Ī) Check all MAC address entries on the switch.ī) Check the MAC address entries on an interface. Output peak rate 13880 bits/sec, Record time: 02:50ģ. ![]() Input peak rate 13880 bits/sec, Record time: 02:50 Last 300 seconds output rate 480 bits/sec, 0 packets/sec Last 300 seconds input rate 480 bits/sec, 0 packets/sec IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx PVID : 1, TPID : 8100(Hex), The Maximum Frame Length is 1600 Switch Port, Link-type : trunk(configured), ![]() System bridge MAC address: xxxx-xxxx-xxxxĢ. This post is regarding the procedure of checking the MAC addresses on a switch.
0 Comments
Leave a Reply. |